Points to Note When Operating Shell-and-Tube Heat Exchangers

Apr 05, 2026 Leave a message

In industrial production, shell-and-tube heat exchangers are widely used heat exchange equipment. Compared with other types of indirect heat exchangers, they provide a much larger heat transfer area per unit volume and have a better heat transfer effect. The following points should be noted when operating shell-and-tube heat exchangers:

(1) Initial operation should be slow, with preheating and gradual temperature increase;

(2) Proper preheating of the pressure reducing valve and adjustment after operation are crucial;

(3) When starting the unit, the cold-side valve should be opened first, and the hot-side valve opened only after stabilization; when shutting down, the hot-side valve should be closed first, followed by the cold-side valve;

(4) After normal operation, close the bypass valve of the steam-water heat exchanger drain condensate, and the drain condensate will be put into normal operation. If the steam trap temperature is too low, such as below 50℃, the bypass valve can be opened. If the steam trap temperature is too high, such as above 90℃ and the condensate system is running without pressure, the bypass valve should be closed to prevent steam from passing through and causing steam-water impact.

(5) Operation adjustment: Operation adjustment is mainly based on weather changes to adjust the water supply temperature and flow rate. Operators mainly control the superheated steam inlet flow rate of the shell-and-tube heat exchanger in the first stage of the heat unit to control the unit outlet water temperature. When the outdoor temperature is high, the temperature is controlled by controlling the number of operating equipment and adjusting the inlet steam flow rate. However, care should be taken to minimize the frequency of heat exchanger operation to avoid leakage of the sealing gasket due to frequent start-stop. When the heating load decreases, attention should be paid to steam pipe drainage to prevent water hammer in the heat exchanger. Operation adjustment should be carried out in a coordinated manner throughout the entire system and uniformly allocated.

Send Inquiry

Send Inquiry