How To Maintain A Shell-and-tube Heat Exchanger After It Has Been Shut Down For An Extended Period?

May 05, 2026 Leave a message

If a shell-and-tube heat exchanger is not properly maintained after being shut down for an extended period, problems such as internal corrosion, external rust, and aging of seals may occur. The core maintenance focuses on "drying, corrosion prevention, and sealing," and is divided into two steps: internal and external maintenance, adapted to different media conditions. Internal maintenance steps:

1. Drain the media: Thoroughly drain all media from the tube side and shell side, open all inlet and outlet valves and drain ports, and use compressed air to blow away any accumulated water, ensuring no liquid remains;

2. Internal corrosion prevention: If the material is carbon steel, spray rust-preventive oil or passivating agent inside the tube side and shell side to prevent internal rusting; if the material is stainless steel, rinse thoroughly with clean water and then blow dry to avoid residual chloride ions causing pitting corrosion;

3. Sealing protection: Apply rust-preventive grease to the connection points between the heat exchange tubes and the tube sheet, as well as the sealing surfaces, to prevent corrosion. External Maintenance Steps:

1. Clean the surface: Remove dust, oil, and debris from the exterior of the equipment. Grind and remove rust from the exterior, and reapply anti-corrosion primer and topcoat.

2. Insulation layer inspection: If there is an insulation layer, check its integrity, moisture-proof layer, and protective layer. Repair any damage promptly to prevent moisture ingress.

3. Overall sealing: Wrap the entire equipment in plastic film or rainproof cloth to prevent dust and rainwater from entering. Install protective covers on valves, instruments, and other accessories to prevent damage.

4. Regular inspection: Unwrap the equipment monthly to check for corrosion and water accumulation inside and outside the equipment, and address any issues promptly. Additionally, apply anti-rust grease to anchor bolts, supports, and other metal parts to prevent rusting and loosening.

Send Inquiry

Send Inquiry